Plug'nPilot™ Martian2 140 V1 STEM CTE DIY Solderless Drone Kit from Cyclone FPV
The new Plug'nPilot™ Martian2-140 V1 kit has been posted for sale as of December 16th, 2021 from Cyclone FPV. We are preparing a new series of videos that will walk you through the building and programming process. If you would like to order your new Plug'nPilot™ Martian2-140, V1 please click here.
If you find yourself stuck on a particular step, please click here to access our troubleshooting page.
Plug'nPilot™ Martian2-140 V1 Build Part 1: Introduction
Plug'nPilot™ Martian2-140 V1 Build Part 2: Frame Assembly
Plug'nPilot™ Martian2-140 V1 Build Part 3: Flight Controller Installation
Plug'nPilot™ Martian2-140 V1 Build Part 4: Motor Installation
Plug'nPilot™ Martian2-140 V1 Build Part 5: VTX Installation
Plug'nPilot™ Martian2-140 V1 Build Part 6: Camera Installation
Plug'nPilot™ Martian2-140 V1 Build Part 7: Receiver Installation
Plug'nPilot™ Martian2-140 V1 Build Part 8: Clean and Close
Plug'nPilot™ Martian2-140 V1 Build Part 9: Betaflight Installation
Plug'nPilot™ Martian2-140 V1 Build Part 10: Loading STM Com Drivers
Plug'nPilot™ Martian2-140 V1 Build Part 11: Firmware Flash and DFU Drivers
Plug'nPilot™ Martian2-140 V1 Build Part 12: Port and Configuration Tabs
Plug'nPilot™ Martian2-140 V1 Build Part 13: Load and Flash BLHeli
Plug'nPilot™ Martian2-140 V1 Build Part 14: Motor Calibration
Plug'nPilot™ Martian2-140 V1 Build Part 15: Motor Direction
Plug'nPilot™ Martian2-140 V1 Build Part 16: VTX Setup
You have completed the configuration of your drone. You must now complete the configuration of your Transmitter and Receiver. Please click one of the two links below to transfer to your Radio and Receiver Page.
- HotRC Radio and Receiver
- FrSky X9Lite Radio and Receiver