Plug'nPilot™ Martian2 140 V2 STEM CTE DIY Solderless Drone Kit
The new Plug'nPilot™ Martian2-140 V2 kit has been posted for sale as of January 10th, 2021, from Cyclone FPV. We are preparing a new series of videos that will walk you through the building and programming process. If you would like to order your new Plug'nPilot™ Martian2-140, V2 please click here.
If you find yourself stuck on a particular step, please click here to access our troubleshooting page.
Plug'nPilot™ Martian2-140 V2 Build Part 1: Introduction
Plug'nPilot™ Martian2-140 V2 Build Part 2: Frame Assembly
Plug'nPilot™ Martian2-140 V2 Build Part 3: Flight Controller Installation
Plug'nPilot™ Martian2-140 V2 Build Part 4: Motor Installation
Plug'nPilot™ Martian2-140 V2 Build Part 5: VTX Installation
Plug'nPilot™ Martian2-140 V2 Build Part 6: Camera Installation
Plug'nPilot™ Martian2-140 V2 Build Part 7: Receiver Installation
Plug'nPilot™ Martian2-140 V2 Build Part 8: Clean and Close
Plug'nPilot™ Martian2-140 V2 Build Part 9: Betaflight Installation
Plug'nPilot™ Martian2-140 V2 Build Part 10: Loading STM Com Drivers
Plug'nPilot™ Martian2-140 V2 Build Part 11: Firmware Flash
Plug'nPilot™ Martian2-140 V2 Build Part 12: Port, Configuration, and Motor Tabs
Plug'nPilot™ Martian2-140 V2 Build Part 13: Load and Flash BLHeli
Plug'nPilot™ Martian2-140 V2 Build Part 14: Motor Calibration
Plug'nPilot™ Martian2-140 V2 Build Part 15: Motor Direction
Plug'nPilot™ Martian2-140 V2 Build Part 16: VTX Setup
There are two VTX Versions with this build. Please look closely at your VTX and then choose the video below that corresponds to your model:
- If the vtx you have has 5848 printed on the back, please use the video below:
You have completed the configuration of your drone. You must now complete the configuration of your Transmitter and Receiver. Please click one of the two links below to transfer to your Radio and Receiver Page.
- HotRC Radio and Receiver
- FrSky X9Lite Radio and Receiver