DT140v1 Plug'nPilot™ Video Build Series

DT140v1 Plug'nPilot™ Video Build Series from Cyclone FPV

The video series below covers the installation of the Plug'nPilot™ DT140v1 drone kit from CycloneFPV. If you purchased the CycloneFPV DIY+ DT140v1, you will need to click here to visit the DIY+ video series section. 

Part 1: Drone Parts Review and Discussion

Part 2: Frame Assembly

Part 3: Flight Controller Installation

Part 4: VTX Installation

Part 5: Motor Installation

Part 6: Camera Installation

Part 7: Receiver Installation

Part 8: Receiver Antenna Installation

Part 9: LocTite Installation

Part 10: Betaflight Firmware Update 

Part 11: Betaflight Ports and Configuration

Part 12: Betaflight Power and Battery Configuration

Part 13: Betaflight Failsafe Configuration 

Share this post...

Next post